The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
- Coupling and power shafts
- Coupling
Removal and coupling installation
Removal and installation of the bearing of deenergizing of coupling
Removal of air from a coupling drive
Removal and installation of the working cylinder of coupling
+ Power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes
|
Removal and installation of the bearing of deenergizing of coupling
Noise in the bearing of deenergizing of coupling in the switched off condition, that is at the pressed pedal of coupling, specifies in damage to the bearing. At replacement of a conducted disk it is recommended to replace necessarily also the considered bearing.
|
|
|
1 Remove manual transmission, address to Section Removal and installation manual transmission.
|
2 Remove the bearing-1 from a primary shaft of a box. Take out from spring скобы-5 lever-4 and remove it.
|
|
-1 and-2 designate adjoining surfaces of the bearing and the lever of deenergizing of coupling. |
|
3 Check up a hand the bearing. For this purpose slightly compress the bearing and повращайте it. It should rotate easily. Otherwise replace it. |
|
|
|
|
1 Clear the lever and slightly grease its surfaces of sliding - F - greasing “ESSO UNRIX S2”. |
|
2 In the presence of damages replace spring скобу-5 and шаровый a finger-6. |
|
3 Wipe directing plug-7.
|
|
Do not grease directing plug, otherwise the bearing of deenergizing of coupling can заедать on the directing plug. |
|
4 Establish the lever with the bearing on primary shaft manual transmission and fix spring скобой.
|
5 Clear sliding surfaces on the bearing of deenergizing of coupling. Do not wash out the bearing in gasoline. Surfaces-2 bearings of deenergizing of coupling should adjoin to surfaces-3 levers. |
6 Establish manual transmission, address to Section Removal and installation manual transmission. |
|
|
|