BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
- Automatic transmission
   Removal and installation АТ
   Adjustment of draught of the selector
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes





Adjustment of draught of the selector

Lifting and car installation on supports are dangerous! Therefore preliminary familiarise with Razdelom Poddomkrachivanie and towage


 PERFORMANCE ORDER

1 Lift and establish the car horizontally on supports. Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
2 Establish the selector in position “Р”.

3 Oslabte a nut-2 on the lever boxes-3, keeping thus the tightening plug-1 wrench from проворачивания.

4 Wring out the lever of a box-3 forward in parking position. Thus pull a cable-4 in an opposite direction and again release it.
5 Tighten a nut-2 moment 10 Н•м, keeping thus the tightening plug-1 for шестигранник.
6 Check up selector work. For this purpose include ignition. At the motionless car the selector can move from position “Р” or “N” if the brake pedal is simultaneously pressed.
7 Engine can be started only in position of selector "" and “N”.
8 Ignition key can be taken out only in selector "" position.
9 Otherwise it is necessary to address on HUNDRED.