BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
- Systems of cooling, heating
   - System of cooling of the engine
      Replacement of a cooling liquid
      Thermoswitch check
      Check of system of cooling under pressure
      Connection and separation quick disconnect муфты
      Removal and thermostat installation
      Removal and installation of the fan / of a casing of the fan
      Removal and installation of the fan with вязкостной муфтой
      Removal and radiator installation
      Removal and installation of the pump of a cooling liquid
   + Heater and the conditioner of air of salon
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes





Connection and separation quick disconnect муфты

Hoses and joinings of a cooling liquid incorporate quick disconnect муфтами. Connection/separation quick disconnect муфты is described on an example муфты the top hoses of a radiator.

Opening

1 Merge cooling liquid in capacity, address to Section Replacement of a cooling liquid.

2 Take out upward a screw-driver wire clamps-1 and-2.


3 Separate муфту.

Connection


4 Check up sealing rings in connections quick disconnect муфт. In the presence of damages replace.

It is not necessary to grease sealing rings with any greasing.


5 Press before installation wire clamps on муфте.
6 Connect муфту. Thus clamps should be fixed distinctly.
7 Fill system with a cooling liquid and remove from system air, address to Section Replacement of a cooling liquid.