|
|
BMW 3 series E46Since 1998 of releaseRepair and car operation |
|
|
The BMW of 3 series Е46 + Cars BMW 3 (Е46) + Current leaving and service + The engine + Systems of cooling, heating - Power supply systems, injection and release Security measures and rules of observance of cleanliness at work with fuel system Removal and installation of the gauge of a stock of fuel / the fuel pump Check of the gauge of a stock of fuel - The power supply system of petrol engines Removal, installation and check of the relay of the fuel pump Removal and installation of the fuel filter Removal, installation and adjustment of a drive throttle заслонки Removal and installation of the air filter of the engine + System of injection of fuel of the petrol engine + The power supply system of diesel engines + System of release of the fulfilled gases + Engine electric equipment + manual transmission and трансмиссионная a line + Automatic transmission + Coupling and power shafts + Brake system + Suspension bracket and steering + Body + Onboard electric equipment + Electric equipment schemes |
The power supply system of petrol engines
1 Lift and establish the car horizontally on supports. Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment. 2 Establish the selector in position “Р”.
4 Wring out the lever of a box-3 forward in parking position. Thus pull a cable-4 in an opposite direction and again release it. 5 Tighten a nut-2 moment 10 Н•м, keeping thus the tightening plug-1 for шестигранник. 6 Check up selector work. For this purpose include ignition. At the motionless car the selector can move from position “Р” or “N” if the brake pedal is simultaneously pressed. 7 Engine can be started only in position of selector "" and “N”. 8 Ignition key can be taken out only in selector "" position. 9 Otherwise it is necessary to address on HUNDRED. |
|