BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   + Дигностика electric elements
   + Illumination and the alarm system
   - Devices and the equipment
      Monitors - the basic data
      Removal and control panel installation
      Removal and installation of the index of turn/switch of a screen wiper
      Removal and installation of facing of a steering column
      Removal and installation of the switch of light
      Removal and installation of switches: seat heating / sun-protection curtain/system Hi-Fi/antiprobuksovochnoj of system ASR
      Removal and installation of switches: the alarm system, the uniform lock, window lifters
      Removal and radio receiver installation
      Removal and loudspeaker installation
      Removal and installation of the electric motor/draughts of a screen wiper
      Pump check стеклоомывателя
      Explanatory remarks to schemes of electric connections
+ Electric equipment schemes





Explanatory remarks to schemes of electric connections

The schemes of electric connections resulted further are made by a schematic principle when components of each contour communicate among themselves on the shortest way without the form of a lining of electroconducting round located on a way of its following of components and plaits.

On cars BMW the single-wire scheme of inclusion of devices of an electric equipment is applied. With plus of power supplies consumers incorporate a wire, and to a minus – through a body of the car or on weight. Such method allows to reduce number of wires and to simplify their installation. Connection with weight of a minus of power supplies reduces electrochemical corrosion of metal details of a body. In certain cases it is not enough direct connection of the electric consumer with weight, and the consumer incorporates to weight an additional wire of usually brown colour.

Pressure of a food is brought to the majority of consumers through the ignition switch. Feed circuits of those knots of the electric equipment which work can be demanded in any circumstances, are always connected to the storage battery, irrespective of position of a key in the ignition lock.
For connection of wires electric sockets with flat contacts are used.

For a normal food of consumers the electric chain should be closed, otherwise вней there will be an electric current, for example, if to the screen wiper electric motor positive pressure moves, it will not work until its electric chain will not be connected to weight. In an electric chain switches, the relay, safety locks, measuring devices, electric motors and other consumers of the electric power can be connected. For correct connection of consumers of the electric power contacts of electric sockets have corresponding marks. Connection with weight of the car is carried out or is direct through the case of the consumer of the electric power or an additional wire.

Contact 30

On this contact always there is a positive pressure of the accumulator. The wires connected to this contact, have red or red colour with a strip.

Contact 31


Contact incorporates to weight of the car a wire of brown colour.

Contact 15


On this contact positive pressure after ignition inclusion moves. The wires connected to this contact, have green or green colour with a strip.

Contact Х


On contact pressure after ignition inclusion moves, however at inclusion of a starter pressure is disconnected. It gives the chance to disconnect at engine start consumers of the electric power unnecessary at this moment. Headlight headlights receive a food also from this contact, therefore at the included headlight and ignition deenergizing there is an automatic switching on dimensional fires.

Colours of wires are designated by Latin letters.


If in a colour designation проводаимеется some letters divided by a sign / the left group of letters specifies in primary colour of a wire, and right – on colour of a strip.

On the scheme all consumers of a current and switches are represented in neutral position.

Designations of colours of isolation электропроводки*

ВLK

The black

BLU

Dark blue

BRN

The brown

GRY The grey
GRN The green
LT Light (shade)
NCA It is not defined
ORG The orange
PNK The pink
PPL The purple
RED The red
TAN The golden
VIO The violet
WHT The white
YEL The yellow
* OR OR
For example: BRN/VIO OR GRY/BRN — Brown with the Violet strip or Grey with the Brown strip