BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   + Дигностика electric elements
   + Illumination and the alarm system
   - Devices and the equipment
      Monitors - the basic data
      Removal and control panel installation
      Removal and installation of the index of turn/switch of a screen wiper
      Removal and installation of facing of a steering column
      Removal and installation of the switch of light
      Removal and installation of switches: seat heating / sun-protection curtain/system Hi-Fi/antiprobuksovochnoj of system ASR
      Removal and installation of switches: the alarm system, the uniform lock, window lifters
      Removal and radio receiver installation
      Removal and loudspeaker installation
      Removal and installation of the electric motor/draughts of a screen wiper
      Pump check стеклоомывателя
      Explanatory remarks to schemes of electric connections
+ Electric equipment schemes





Removal and installation of the electric motor/draughts of a screen wiper

 REMOVAL

1 Electric motor of a screen wiper before removal establish in a starting position. For this purpose moisten a windscreen with water and include the electric motor for short time. Then stop the electric motor the switch of a screen wiper and result it in final position.
2 Disconnect a negative cable (-) the storage battery at the switched off ignition. The battery is in a luggage compartment behind a cover on the right side. At cars BMW 316i, 318i the battery settles down in an impellent compartment.

As a result of switching-off of the storage battery the data from memory of malfunctions of some monitors is erased. If necessary before battery switching-off it is necessary to consider the given memories of malfunctions. Address to Section Diagnostics of malfunctions. Work it is desirable to spend HUNDRED in conditions.

3 Remove the air filter of ventilation of salon, address to Section Replacement of an element of the filter of air of salon.
4 Remove a box of the air filter, address to Section Removal and installation of a box of an air inlet.
5 Remove запорную a heater wall, address to Section Removal and installation of the fan of a heater.
6 Remove both levers of a screen wiper, address to corresponding section.
7 Uncover front обтекателя, address to Section Removal and cover installation обтекателя.

8 Rasstykujte a socket-1 electric motors of a screen wiper.

9 Turn out a bolt-2 consoles of a screen wiper.

10 Turn away a nut of fastening-3 axes of a screen wiper.

11 Take out screen wiper bars in the complete set through an aperture in запорной to a heater wall.

12 Mark a felt-tip pen lever position - 4-in relation to the console. Turn away a nut-5 and.

13 Turn out three bolts of fastening-6 electric motors and remove the electric motor from the console.


 INSTALLATION

14 Complete bars, as is shown in an illustration.

1 — screen wiper bars
2 — the electric motor
3 — a nut
4 — a washer top
5 — a washer bottom
6 — демпфирующее a ring
7 — a bolt with a washer

15 Before electric motor installation result it in a starting position. For this purpose attach the tip, quickly attach a negative cable (-) an accumulator room
Batteries also include the electric motor. Then stop the electric motor the switch of a screen wiper and allow to it to come to final position. Disconnect the tip, disconnect a negative cable of the storage battery.
16 Fix the electric motor on the console of a cleaner the moment 10 Н•м.
17 Establish the lever according to the marks put on the consoles. Fix a nut the moment 25 Н•м.
18 Establish bars and fix 2 nuts the moment 12 Н•м
19 Establish rubber support of the console of a cleaner on an axis and fix the console the moment 10 Н•м.
20 Join an electric motor socket.
21 Establish front обтекатель, address to Section Removal and cover installation обтекателя.
22 Establish both levers of a cleaner, address to corresponding section.
23 Establish запорную a heater wall, address to Section Removal and installation of the fan of a heater.
24 Establish a box of the air filter, address to Section Removal and installation of a box of an air inlet.
25 Establish the air filter of ventilation of salon, address to Section Replacement of an element of the filter of air of salon.
26 Attach a negative cable (-) the storage battery at the switched off ignition. Establish hours.