BMW 3 series E46

Since 1998 of release

Repair and car operation


The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (сервоуправление)
      Removal and installation of the block of a pillow of safety on a steering wheel
      Removal and steering wheel installation
      Removal and installation of a tip of steering draught
      Removal and installation of steering draught
      Removal and installation of the pump of the hydraulic booster
      Filling with a liquid and removal of air from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes




Removal and installation of the block of a pillow of safety on a steering wheel

Before removal of the block of a pillow of safety necessarily familiarise with instructions on security measures.


 REMOVAL

1 Disconnect a negative cable (-) the storage battery at the switched off ignition. The storage battery is located in a luggage carrier behind a cover on the right side. At BMW 316i, 318i the storage battery is located in an impellent compartment.

At switching-off of the storage battery the given memories of malfunctions of separate devices are erased. If necessary before battery switching-off consider the given memories. Address to Section Diagnostics of malfunctions. Work it is desirable to spend HUNDRED in conditions.

2 Unblock a steering column and extend how much it probably steering wheel and establish it in extreme bottom position.
3 Turn a steering wheel on угол90 (1/4 turns) from average position so that spokes stood vertically.

4 Turn on screw-driver Torx Т30-2 behind the top screw of fastening of a steering wheel-1. For отворачивания the screw the face angular key can be applied. Turn a steering wheel on 180 (1/2 turns) and completely turn away the second screw of fastening of a pillow of safety. Screws remain in a steering wheel.

5 hook a screw-driver the block of a pillow of safety a little. Press a clamp of the tip of a pillow of safety and расстыкуйте a socket. If is available, расстыкуйте a socket of a multifunctional steering wheel.
6 Remove the block of a pillow of safety and put its soft party upwards, for example, in a luggage carrier.


 INSTALLATION

7 Check up, whether the negative cable (-) the storage battery is disconnected.
8 Fix a socket of the block of a pillow of safety so that click was heard. If there is a socket of a multifunctional steering wheel, join it.
9 Establish into place the block of a pillow of safety and fix it from an underside of a steering wheel the moment 2 Н•м динамометрическим key HAZET–6108–1 CТ and a head 2223-T30. Thus watch that the cable has not been clamped.

During switching-off of the storage battery the finding in the car of people is not supposed.

10 Attach a negative cable (-) the storage battery at the switched off ignition, establish time for hours.