BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (сервоуправление)
      Removal and installation of the block of a pillow of safety on a steering wheel
      Removal and steering wheel installation
      Removal and installation of a tip of steering draught
      Removal and installation of steering draught
      Removal and installation of the pump of the hydraulic booster
      Filling with a liquid and removal of air from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of the pump of the hydraulic booster

The petrol engine

 REMOVAL

1 Suck away oil from the tank by means of the corresponding device or usual шлицем.
2 Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
3 Remove клиновой a belt, address to Section Removal, installation and a tension клинового a belt.

Hit in hydrosystem of any pollution is not supposed. Open pipelines and hoses close stoppers or polyethylene, having fixed its rubber plait.

4 Release a collar-1 and disconnect soaking up hose.

5 Turn on накидную a nut and disconnect a pressure head line-2.
6 Turn away bolts of fastening-3 and disconnect a pulley keeping it from rotation for internal шестигранник-4 shaft of the pump a face key on 10 mm.

7 Turn on from above two bolts of fastening-6 pumps of the hydraulic booster and remove the pump.-3 bolts of fastening of a pulley,-7 pulley.


 INSTALLATION

8 Insert into place the pump of the hydraulic booster and fix its bolts.
9 Establish into place a pulley and fix it.
10 Fix a pressure head line накидной a nut.
The moments of an inhaling depending on diameter of a carving the following:

М10 - 12 Н•м
М14 - 35 Н•м
М16 - 40 Н•м
11 Put on клиновой a belt, address to Section Removal, installation and a tension клинового a belt.
12 Establish the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
13 Fill system with new oil and remove from system air.

Repeatedly it is not necessary to apply the liquid which was in the use.