|
BMW 3 series E46Since 1998 of releaseRepair and car operation |
|
The BMW of 3 series Е46 + Cars BMW 3 (Е46) + Current leaving and service + The engine + Systems of cooling, heating + Power supply systems, injection and release + Engine electric equipment + manual transmission and трансмиссионная a line + Automatic transmission + Coupling and power shafts + Brake system - Suspension bracket and steering + Forward suspension bracket + Back suspension bracket - Steering with the hydraulic booster (сервоуправление) Removal and installation of the block of a pillow of safety on a steering wheel Removal and steering wheel installation Removal and installation of a tip of steering draught Removal and installation of steering draught Removal and installation of the pump of the hydraulic booster Filling with a liquid and removal of air from hydrosystem of the amplifier of a wheel Corners of installation of forward wheels. Check of installation of wheels + Body + Onboard electric equipment + Electric equipment schemes |
Corners of installation of forward wheels. Check of installation of wheels Corners of installation of wheels appreciably influence stability of the car, deterioration of tyres and the fuel expense. Distinguish following corners of installation of wheels:Disorder is an inclination of a wheel in a vertical plane concerning an average line of the car. It can be positive if wheels are inclined outside or negative if wheels are inclined inside. The disorder corner, basically, influences uniformity of deterioration of tyres of forward wheels. If disorder of one wheel positive, and another negative the car will withdraw aside at movement on a straight line. Convergence – a difference of distances between forward and back edges of wheels. The positive convergence means that wheels are in front located is more close to each other, than behind at measurement at height of an average point of a wheel. The negative convergence means that wheels in front are on большем distance from each other, than behind. The cross-section inclination of an axis of turn of a wheel is a corner between an axis of an inclination of a rotary fist and a vertical spent through a point of fastening of a wheel, looking in a longitudinal direction of the car. At the expense of corners of disorder and a cross-section inclination of an axis of turn of a point of a contact of wheels with road settle down more close to an axis of a rotary fist. It supports so-called “a shoulder обкатки”, the driving is easier. Also blows from roughness of a covering are less transferred to a steering. Corner of a longitudinal inclination of an axis of turn. The axis concerning which there is a wheel turn, takes places in space so that its bottom part is directed forward. Such corner of a longitudinal inclination is called as positive. At positive value of a corner self-return of a wheel to average position after turn improves. Convergence adjustment 1 Establish forward wheels directly. On the helmsman to a shaft and картере the steering mechanism there are marks. Establish a steering so that the specified marks have coincided. 3 After the termination of adjustment of a convergence tighten tightening bolts at steering draughts the moment 80 Н•м. |
|