BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering with the hydraulic booster (сервоуправление)
      Removal and installation of the block of a pillow of safety on a steering wheel
      Removal and steering wheel installation
      Removal and installation of a tip of steering draught
      Removal and installation of steering draught
      Removal and installation of the pump of the hydraulic booster
      Filling with a liquid and removal of air from hydrosystem of the amplifier of a wheel
      Corners of installation of forward wheels. Check of installation of wheels
+ Body
+ Onboard electric equipment
+ Electric equipment schemes


Смотрите подробности максимус официальный сайт калининград на нашем сайте.



Removal and installation of steering draught

 REMOVAL

1 Mark a paint position of a forward wheel concerning a nave. It will allow to establish отбалансированное a wheel in the former position. Ослабьте bolts of fastening of a wheel at the car standing on the earth. Lift a forward part of the car and remove a wheel
2 Remove the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
3 Remove by means of a stripper the hinge of steering draught from a rotary fist, address to Section Removal and installation of a tip of steering draught.

4 Oslabte fastening of a collar also shift back a cover.

5 Move gear рейку as it is possible more deeply to exclude possible damage рейки and its support.

6 Turn away steering draught from gear рейки (an arrow on an illustration).


 INSTALLATION

7 Measure gear рейку. If new steering draught is established, screw it so that to provide the size which has been removed at measurement of old draught.
8 Tighten a tightening nut of a tip of steering draught the moment 80 Н•м.
9 If it is necessary, clear of greasing a pin of the hinge of steering draught, and also a seat in a rotary fist.
10 Check up a cover and if necessary replace it.
11 Fix steering draught not gear рейке the moment 100 Н•м.
12 Put on a cover and fix its collar. Watch that the cover has not been braided.
13 Insert a tip into a rotary fist. Screw a new self-stopped nut on a pin of the hinge of steering draught and tighten the moment 65 Н•м.
14 Establish into place a wheel so that the marks put at removal, have coincided. Preliminary grease with a thin layer подшипниковой greasings a seat of a disk of a wheel on a nave. Bolts of fastening of a wheel do not grease. Rusty bolts replace with the new. Fix a wheel bolts. Lower the car on wheels and tighten bolts cross-wise the moment 100 Н•м.
15 Establish the bottom cover of an impellent compartment, address to Section Removal and installation of the bottom cover of an impellent compartment.
16 Check up a track on HUNDRED, if necessary adjust.