BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   Removal and installation brake колодок forward wheels
   Removal and installation directing forward brakes
   Removal and installation of a brake disk of a forward wheel
   Removal and installation brake колодок disk brakes
   Removal and installation скобы brakes of back wheels
   Removal and installation of a brake disk of a back wheel
   Measurement of a thickness of a brake disk
   Brake liquid - the basic data and security measures
   Removal of air from brake system
   Replacement of the brake pipeline
   Replacement of a forward brake hose
   Check of the amplifier of a brake
   Removal and installation колодок a lay brake
   Adjustment of a lay brake
   Removal and installation of the lever of a lay brake
   Removal and installation of a cable of a drive of a lay brake
   Removal and installation of the switch of a stoplight
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of the switch of a stoplight

The stoplight switch is located around feet at a support of a pedal of a brake. It represents the contactless electronic switch and practically has no deterioration.

 REMOVAL

1 Turn away bolts of fastening and uncover in the left part of area of an arrangement of feet, address to Removal and facing installation forward parts of area of feet.

2 Rasstykujte a socket at the switch of a stoplight-1, for this purpose compress clamps. 2 – педель brakes. 3 – the coupling switch.

3 Squeeze out a brake pedal. Pull a pusher-1 and a sleeve-2 completely forward-3.

4 In this position remove lock clips-4 and take out the switch back from the holder.


 INSTALLATION

1 Insert the switch with completely extended plug into a support of a pedal and fix.
2 Displace the red lock plug towards the switch so that the plug fillet adjoined to a pedal support.
3 Join a socket and fix it.
4 Check up, whether the stoplight lights up at the switched off ignition and the pressed pedal of a brake.
5 Establish into place a cover around an arrangement of feet, address to Section Removal and facing installation forward parts of area of feet.