BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
- Brake system
   Removal and installation brake колодок forward wheels
   Removal and installation directing forward brakes
   Removal and installation of a brake disk of a forward wheel
   Removal and installation brake колодок disk brakes
   Removal and installation скобы brakes of back wheels
   Removal and installation of a brake disk of a back wheel
   Measurement of a thickness of a brake disk
   Brake liquid - the basic data and security measures
   Removal of air from brake system
   Replacement of the brake pipeline
   Replacement of a forward brake hose
   Check of the amplifier of a brake
   Removal and installation колодок a lay brake
   Adjustment of a lay brake
   Removal and installation of the lever of a lay brake
   Removal and installation of a cable of a drive of a lay brake
   Removal and installation of the switch of a stoplight
+ Suspension bracket and steering
+ Body
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of a brake disk of a back wheel

 REMOVAL

1 Remove directing brakes with a support, address to corresponding section. A brake hose do not disconnect. Otherwise after installation it is necessary to delete air from system.
2 Suspend on a wire скобу directing a brake/support to a suspension bracket. Watch that the hose was not overwound.

3 Turn out the fastening screw (the marksman on an illustration) a face key on 5 mm.

4 Completely release a lay brake.
5 Remove a brake disk. If the disk does not act in film, displace back brake колодки a lay brake, address to Section Removal and installation колодок a lay brake.


 INSTALLATION

For achievement of uniform braking from both parties both brake disks should have identical surfaces concerning quality and a roughness. Therefore necessarily it is necessary to replace or pierce both disks of one axis.

On HUNDRED it is possible to check up a brake disk on palpation, admissible values are resulted in Specifications.

6 Measure a thickness of a brake disk, address to Section Measurement of a thickness of a brake disk.
7 Clear new brake disks a nitrothinner of a protective film.
8 Establish a brake disk on a nave and turn so that apertures under the fastening screw have coincided. Tighten the screw a face key the moment 16 Н•м.
9 Establish into place directing brakes with a support, address to corresponding section.

If the brake hose was disconnected, fix it and remove from system air, address to Section Removal of air from brake system.

10 Adjust a lay brake, address to Section Adjustment of a lay brake.
11 New brake disks it is necessary to earn extra cautiously for three receptions.

The first reception: five braking since speed of 50 km/hour strong pressing a brake pedal road where there is no traffic.
The second reception: Allow to brakes to be cooled.
The third reception: 5 More braking since speed of 50 km/hour.