BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ manual transmission and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   + External elements of a body
   - Internal elements of a body
      Removal and installation of forward peaks of the panel of devices
      Removal and facing installation forward parts of area of feet
      Removal and installation of the left ware box
      Removal and installation of the right ware box
      Removal and installation of the central console
      Removal and installation of the central armrest
      Removal and installation of a pocket of the console of switches
      Removal and installation of the console of switches
      Removal and installation of the electric motor of a drive сдвижной roof panels
      Removal and installation of a mirror of an interior
      Mirror of an interior with automatic blackout
      Removal and installation of lateral facing of a luggage carrier
      Removal and installation of facing of the back panel
      Removal and installation of facing of a cover of a luggage carrier
      Removal and installation of a headrest of a forward seat
      Натяжитель a seat belt. The basic data and security measures
      Removal and installation of a forward seat
      Removal and installation of a back seat
      Removal and installation of atomizers стеклоомывателя
      Adjustment of atomizers стеклоомывателя
      Removal, installation and check of atomizers фароомывателя
      Removal and installation of levers of a screen wiper
      Removal and installation of the tank/pump of a washer
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of levers of a screen wiper

 REMOVAL

1 Moisten a windscreen with water.
2 Include for short time a screen wiper and stop its switch. Thus the cleaner stops in a starting position.
3 Disconnect a negative cable (-) the storage battery at the switched off ignition. The battery is in a luggage compartment behind a cover on the right side. At cars BMW 318i the battery settles down in an impellent compartment.

As a result of switching-off of the storage battery the data from memory of malfunctions of some monitors is erased. If necessary before battery switching-off it is necessary to consider the given memories of malfunctions. Address to Section Diagnostics of malfunctions. Work it is desirable to spend HUNDRED in conditions.

4 Note on a windscreen position of a brush of a screen wiper. For this purpose near to a brush paste on strip glass.

5 Remove a screw-driver of a cover from screen wiper fastening at the left and on the right.

6 Turn away a nut-1.

7 Remove both levers by means of a usual stripper from axes.

Levers sit very strongly and do not act in film without the special tool. The aperture of cams of a stripper should be not less than 16.3 mm. On an accompanying illustration stripper BMW – 616000 is represented. However it is possible to apply also tool HAZET 1966-5.

On an illustration, for an example, the lever of other car is shown.

8 Take out adjusting plugs from cleaner levers.


 INSTALLATION

9 Establish into place the lever and expose it according to the marks put on a windscreen.

10 Establish on an axis-2 adjusting plug-1 and press it заподлицо with the lever-3.

11 Fix the lever the moment 25 Н•м and through 15 mines once again the moment 25 Н•м.
12 Put a cover on a fastening nut.
13 Similarly establish the second lever.
14 Attach a negative cable (-) the storage battery at the switched off ignition. Establish hours.