BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ РКПП and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a forward bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a back bumper
      Removal and installation of the back shock-absorber
      Removal and cover installation обтекателя
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and installation of a cover of a luggage carrier
      Adjustment of a cover of a luggage carrier
      Removal and installation of the lock/cylinder of the lock of a cover of a luggage carrier
      Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier
      Replacement молдингов and model emblems
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation electric стеклоподъемника
      Removal and electric motor installation стеклоподъемника
      Removal and installation of a mirror of an external kind / a sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Electric equipment schemes


tilted uterus in pregnancy



Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier

 REMOVAL

1 Open a cowl/cover of a luggage carrier and prop up them.

If газонаполненный the emphasis does not act in film, it cannot hold a cover in open position.

2 Cover of a luggage carrier: Remove sideways a lock washer-1. Below by means of a screw-driver remove spring скобу-2 a little, without removing it, and wring out газонаполненный an emphasis from a spherical head.

The emphasis is under loading.

3 Cowl: Disconnect an emphasis from above and from below from spherical support for what a screw-driver take spring скобы a little, without removing them.

The gazonapolnennyj emphasis is under loading.


 INSTALLATION

4 Insert lock скобу-1 from edge in шлиц an emphasis.

5 Establish an emphasis a screw-driver on a spherical support and completely enter lock скобу in шлиц.
6 Cover of a luggage carrier: Insert an emphasis from above over a pin and establish sideways a lock spring.

Recycling газонаполненного an emphasis

If газонаполненный the emphasis is replaced, before its recycling it is necessary to remove gas from an old emphasis. For this purpose the emphasis is necessary for clamping in a vice in area H = 50 mm.

The emphasis should be clamped in this place, otherwise there is a danger! Then it is necessary to saw through the cylinder in first third of its general length, counting from a base edge from outside a rod. To collect pouring out oil, area реза it is necessary to close a rag. Besides, during cutting it is necessary to use goggles.