BMW 3 series E46

Since 1998 of release

Repair and car operation



The BMW of 3 series Е46
+ Cars BMW 3 (Е46)
+ Current leaving and service
+ The engine
+ Systems of cooling, heating
+ Power supply systems, injection and release
+ Engine electric equipment
+ РКПП and трансмиссионная a line
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   The general information and security measures
   + Leaving and repair of damages of a body
   - External elements of a body
      Removal and installation of a forward bumper
      Removal and installation/check of shock-absorbers of a bumper
      Removal and installation of a back bumper
      Removal and installation of the back shock-absorber
      Removal and cover installation обтекателя
      Removal and installation of a forward wing
      Removal and cowl installation
      Cowl adjustment
      Removal and installation of a cover of a luggage carrier
      Adjustment of a cover of a luggage carrier
      Removal and installation of the lock/cylinder of the lock of a cover of a luggage carrier
      Removal and installation газонаполненного an emphasis of a cowl/cover of a luggage carrier
      Replacement молдингов and model emblems
      Removal, installation and door adjustment
      Removal and installation of facing of a door
      Removal and installation of the lock of a door
      Removal and installation of the cylinder of the lock
      Removal and installation of the external handle of a door
      Removal, installation and window adjustment
      Removal and installation electric стеклоподъемника
      Removal and electric motor installation стеклоподъемника
      Removal and installation of a mirror of an external kind / a sound signal of a high-pitch tone
      Removal and installation of glass of a mirror
      Removal and installation of the case of a mirror of an exterior
   + Internal elements of a body
+ Onboard electric equipment
+ Electric equipment schemes





Removal and installation of a mirror of an external kind / a sound signal of a high-pitch tone

 REMOVAL

1 Lower glass completely downwards.
2 Remove door facing, uncover in the right part above, address to corresponding section.

It is not necessary to remove a lateral pillow of safety.

3 Take out a small screw-driver two clips-2 covers-1 from a forward end face of a door.

4 Uncover-1, thus begin from below. Take out a cover at the door terminator.

5 Take out a cover above from a flat clip (poses. And on an illustration) also wring out so that to provide upwards access to screws of fastening of a mirror.

6 Rasstykujte a socket of protection against a jamming glass (it white / a black cable).

7 Turn away screws of fastening-2 sound signals of a high-pitch tone-1 and remove it.

8 Rasstykujte a socket of a mirror of an exterior.
9 Keeping a mirror outside, turn out the screw-3.
10 Remove a mirror, thus pass through a door electric wires.


 REMOVAL

11 Establish a mirror, thus pass through a door electric wires.
12 Keeping a mirror outside, fix its screw-3.
13 Fix a sound signal of a high-pitch tone. Tighten screws-2 and-3 moment 6 Н•м.
14 Join a socket of a mirror of an exterior and protection against a jamming glass.
15 Press protection against a jamming into a clip - And-.
16 Insert a cover of protection against a jamming on the terminator of a door and fix two clips at a door end face.
17 Establish door facing, address to corresponding section.